![]() With layer height set to 0.2mm and z_step at 0.005mm there will be 4 layers, but with z_step at. I guess I can set that to 0.005mm?Īnother another thing: My part is 0.9mm high. After 11 conically expanding layers, the beginning of gap fill is almost flat (raised by maybe 0.05mm), while the end of gap fill goes by 0.15mm above general. I can say there is approx 15 more fill at the end of the gap fill line than at the beginning. I find it strange that Ironing is enabled by default.Īnother thing: Z full step (z_step) is set at 0.04mm for my printer, I was quite confused as the guy in #784. In this example, Gap fill is moving from right to left (stopped before end of the line). Please refer to the 2nd photo for the print setting (PS on the left, SS on the right) Steps needed to reproduce the problem: just choose a model that has narrow section and generate gcode for. The slicing settings are the same, infill, monotonic on top, adaptive cubic in middle layers, etc. Top Parts have Ironing enabled, right parts Layer heigth is. There are noticeable gaps produced by prusa slicer. In Marlin it will do that with this setting, but Klipper will. the Outer Wall Wipe Distance in Cura) which blurs the seam over that 5mm distance. To eliminate a Z seam, you kinda need to coast past the end of the extrusion (i.e. Parts without Ironing do not have those gaps: The difference is that Klipper will slow down and either stop, or almost stop, at the start/end of an extrusion path. supermerill added a commit that referenced this issue on Aug 21, 2021. supermerill added the fixed for the next version label on Aug 21, 2021. It would be nice to be able to give it more than 100%, as I encounter too little material at Gap fill regions. supermerill changed the title Gap Fill not consistent Add Gap Fill on thin empty surfaces on Mar 18, 2021. ![]() Printed part trying to tweak (the one with Ironing enabled):ĭesktop (please complete the following information): Two parts being sliced: with and without Ironing Bridging is a 3D printing technique that lets makers significantly cut down on print supports. Gap fill overlap does not make much of a change.Īll settings at standard values (0.2mm NORMAL Creality) Printer: Ender 5 plus, direct drive, PEI bed (bobstro) Illustrious Member RE: Stop 'Gap fill' Try setting gap fill speed to 0. 3D Printing Bridging: 6 Tips for Perfect Bridges. Is there any way to turn off Gap Filling in the PRUSA Slicer I have some very thin objects. ![]() It said to report back about that setting: Can I turn off 'Gap Filling' in the PRUSA Slicer. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |